Periodical Controls; Cleaning The Appliance - Berkel BH+25T Mode D'emploi Et D'entretien

Before setting to work:
-
check that the power supply tension corresponds to the value given on the ID plate
-
Check that there are all the warning and ID plates and that they are not damaged
-
Check that the power supply cable is not damaged and is intact
- Check that the safety features such as the magnetic sensors are intact and
not damaged
Functional checks with the appliance running:
-
check the efficiency of the protections and safety features. There is the possibility
that during transport these have been damaged or are out of adjustment
-
Carry out several functional tests using pieces of food that are the same size that
will be used in normal working conditions.
7.5

Periodical controls

To maintain reliability and performance in time, as well as proceeding as indicated, it
is necessary to carry out regular tests and checks as follows:
Before each work shift :
-
every day check safety features and protections work correctly.
-
check the power cable is intact.
the end of the work shift:
-
carefully clean the appliance removing any traces of food
-
remove, clean and mount rotor and blades
7.6

Cleaning the appliance

At the end of the work shift the appliance must be carefully cleaned and disinfected.
-
stop the appliance and switch the on/off switch to "0" and remove the power plug.
-
With a sponge soaked with water and suitable neutral degreasers (non-toxic)
remove and clean any traces of food.
Do not use petrol, solvents or other inflammable liquids such as detergents. Use
authorised non-toxic and non-inflammable solvents.
Take suitable precautions when cleaning considering the products being used. Always
follow the instructions for use given.
ATTENTION!
These mixers are designed for mixing meat, therefore for health reasons you are
obliged to use non-toxic and neutral detergents. For hygiene purposes such deter-
gents must be suitable for cleaning components that come in contact with food.
21