Mounting The Landing Gear; Mounting The Propeller - Reely SKY Piper J-3 Notice D'emploi

i) Mounting the landing gear
• The landing gear wire (1) is inserted into the prepared
landing gear shaft (2) located in front of the flight battery
shaft.
j) Mounting the propeller
• The propeller catch (1) is slid onto the engine shaft up
to the stop position together with the propeller (2).
• Use the enclosed Allen key (3) to tighten the grub screw
on the propeller catch.
• Finally, check the propeller nut (4) once again with the
enclosed fork wrench.
Attention important!
If you align the model horizontally and then look at it from the side, you will quickly notice that the
propeller is not exactly vertical (see ill. 16, interrupted line), but slightly slanted.
This is intentional and not a defect of the model or the motor attachment!
Figure 14
Figure 15
Figure 16
53