Rear Shock Absorbers; Spring Pre-Load Adjustment; Important Notice - Benelli BN600R Manuel D'utilisateur

BN600R

REAR SHOCK ABSORBERS

Spring pre-load adjustment

The rear shock absorber is fi tted with an
adjustment ring nut for the pre-load of
spring *A and a return ring nut (D) *
Adjust the spring pre-load
as follows:
To increase the spring's preload and
therefore make the suspension more
rigid, turn the adjustment ring nut "A" in
direction (B).
C
B
D
A
To reduce the spring's preload and
therefore make the suspension softer,
turn the adjustment ring nut "A" in di-
rection (C). At the end of the adjustment,
tighten the return ring nut (D).
Adjustment of the
brake action in extension
It is possible to adjust the hydraulic
brake device using the adjustment screw
"E" Use a screwdriver to turn it clockwise
to increase the brake action and anti-
clockwise to reduce it.
E
87

IMPORTANT NOTICE:

To avoid damaging the mechanism, do
not try turning over the maximum or min-
imum setting.
Always have the shock absorber adjust-
hydraulic
ed by a Benelli assistance centre.
+
-
UK