Rear Shock Absorbers; Important Notice - Benelli BN600GT Manuel D'utilisateur

REAR SHOCK ABSORBERS

Spring pre-load adjustment
The rear shock absorber is itted with an
adjustment ring nut for the pre-load of
spring *A" and a return ring nut "D"
Adjust the spring pre-load
as follows:
To increase the spring's preload and
therefore make the suspension more
rigid, turn the adjustment ring nut "A" in
direction (B).
To reduce the spring's preload and
D
C
B
therefore make the suspension softer,
turn the adjustment ring nut "A" in di-
rection (C). At the end of the adjustment,
tighten the return ring nut (D).
Adjustment
brake action in extension
It is possible to adjust the hydraulic
brake device using the adjustment screw
"E" Turn in the "F" direction to increase
the brake action or in the "G" direction
to reduce it.
F
A
of the hydraulic
E
G
85

IMPORTANT NOTICE:

To avoid damaging the mechanism, do
not try turning over the maximum or
minimum setting.
Always have the shock absorber adjust-
ed by a Benelli assistance centre.
EN