Battery Inspection - Benelli BN600GT Manuel D'utilisateur

EN

BATTERY INSPECTION

To access the battery compartment:
1. Remove the saddle using the
wrench provided.
2. Remove the 2 screws "B" fastening
the battery lock bracket and re-
move the battery "C".
D
B
Cleaning the terminals
• Once the saddle has been removed,
check the condition of the terminals
"D" and "E".
If they are oxidised, remove the bat-
tery and clean them with a metal
brush.
• After cleaning the terminals apply a
light layer of grease before refitting
the battery.
We recommend using Petronas Tutela
protection grease.
NOTE:
Turn the key to "
the battery.
When the battery is removed, the negative
(Black) terminal must be disconnected
before the positive one (Red). When the
battery is reitted, the positive pole must be
C
connected irst.
Connect the nuts to the terminals.
Once the battery has been inspected, reit
E
the saddle following the steps in reverse
order.
Battery storage
The battery tends to discharge if not
charged on a regular basis. When the
battery is completely lat, chemical reac-
tions occur inside it that will damage it
irreparably.
If the vehicle is not being used for more
than 15 days, the battery must be re-
moved, charged monthly and stored in
a cool, dry place. If the battery is left
on the vehicle, disconnect the negative
electrode (Black).
If the above precautions are not taken,
the battery becomes damaged,
This damage is not covered by guarantee.
" before accessing
102
IMPORTANT NOTICE: