Cooling Fluid Replacement - Benelli BN600GT Manuel D'utilisateur

EN
Lubrication
The chain must only be lubricated at
an Authorised Benelli Workshop, at the
time intervals speciied in the Scheduled
Maintenance Table in this manual.
This operation must also be carried out
every time you ride the bike in rain and
after each wash.
Using the motorcycle with the chain in
bad condition and not lubricated may
cause accidents.
The chain must be correctly lubricated
to guarantee maximum eficiency . Use
Petronas 6 in 1

COOLING FLUID REPLACEMENT

Since the cooling luid replacement may
be dificult for an operator with little ex-
perience, we recommend contacting an
authorised Benelli workshop.
IMPORTANT NOTICE:
This operation must only be carried out
by an Authorised Benelli workshop.
The cooling luid must only be topped up
when the engine is cool.
Never try to remove the cooling luid
tank cap while the engine is hot. Risk of
burns. The circuit is pressurized!
In certain conditions, the ethylene glycol
in the cooling luid may become lamma -
ble and its lame is invisible.
Do not allow cooling luid to come into
contact with hot parts, as the combustion
of ethylene glycol may expose you to the
risk of burns.
Engine cooling luid is harmful if swal-
lowed, or if it comes into contact with
eyes or skin.
Keep the engine cooling luid out of
reach of children and pets.
In the event of swallowing cooling luid,
seek medical aid immediately; do not
provoke vomiting to avoid breathing the
product into the lungs.
In case of cooling luid in contact with
eyes or skin rinse immediately with plen-
ty of water.
100