Benelli BN600GT Manuel D'utilisateur page 92

EN
If the luid level in the tank is close to
minimum, make a visual check of brake-
pad wear.
If the brake pads are not worn, there
may be a leak in the hydraulic circuit.
Contact a Benelli assistance centre for
an inspection as soon as possible.
IMPORTANT NOTICE:
Incorrect maintenance may cause a
brake capacity reduction.
Respect the following precautions:
• Insuficient brake luid may cause
air to enter the brake circuit, caus-
ing a reduction in brake perfor-
mance.
• Clean the iller cap before removing
it. Only use DOT 4 brake luid.
• Only use the prescribed brake luid,
as per the speciica tions. Any other
type could cause the rubber seals
to deteriorate, leading to leaks.
• Top up with the same type of brake
luid. Adding a different type of
brake luid from DOT 4 may cause
a noxious reaction.
• Do not allow water or dust to enter
the brake luid tank while reilling.
IMPORTANT NOTICE:
Brake luid can damage painted surfac-
es or plastic parts. Clean any spilled liq-
uids immediately.
Since brake pads become worn, it is nor-
mal for the luid level in the tank to drop
gradually. If the brake luid level is low it
is possible that the brake pads are worn
and/or that there is a leak in the brake
circuit; therefore, make sure to check
the brake pads for wear and to look for
leaks in the brake circuit.
Topping up and replacing the
disc brake luid
Contact an authorised Benelli mechanic.
90
Check the wear of the brake pads
Make a visual check of brake pad wear
The pads are to be replaced if the wear
indicators can no longer be seen. In this
case contact an authorised Benelli Q.J.
mechanic.
BRAKE PADS
INDICATIONS OF
WEAR
DISC BRAKES