Gear Pedal; Side Stand; Ignition Circuit Cut-Out System - Benelli BN600R Manuel D'utilisateur

UK

GEAR PEDAL

The gear pedal is on the left side of the
engine and it is used in combination with
the clutch lever when changing to one of
the 6 gears on this motorcycle.
6°
5°
4°
3°
2°
N
1°
NOTE:
Always change down one gear at a time
and at the correct speed to avoid en-
gine overspend and jamming of the rear
wheel.

SIDE STAND

The side stand is on the left side of the
vehicle. Lift or lower the side stand with
your feet while holding the vehicle in a
straight position.
NOTE:
The switch built into the side stand is
part of the ignition circuit cut-out system
that cuts out
the ignition in certain situations.
84
BN600R
IMPORTANT:
Do not use the vehicle with the side
stand lowered, or if it cannot
be lifted correctly (or if
it will not stay up), otherwise the side
stand
might not touch ground and distract the
rider with the resulting possibility of los-
ing control of the bike.
The cut-out ignition circuit from Benelli
has been designed to ensure the rider
raises the side stand before putting the
motorcycle in movement. Therefore, we
ask that you check this system regularly,
as described below, and have it repaired
by a Benelli dealer if it does not operate
correctly.
IGNITION CIRCUIT
SYSTEM
The cut-out system for the ignition circuit
(including the side stand switch, neutral
gear smirch and clutch lever switch),
serves the following functions:
• To prevent starting with the gear in
and the side stand raised, with the
clutch lever not pulled.
CUT-OUT