Fine Tuning Of The Helicopter; Setting The Gyrostatic Effect; Adjusting The Rotor Blade Linkage - Reely SKY Jet Ranger Notice D'emploi


11.

Fine Tuning of the Helicopter

a) Setting the Gyrostatic Effect
Besides the receiver and both electronic speed controllers for the electric driven motors, there is also a Piezo gyro-
scope system integrated in the receiver/controller component. This gyroscope system helps the tail of the helicopter to
remain stable when hovering and prevents it from swivelling to the side continuously due to air drafts or air turbulences.
The adjustment controller for the contact sensitivity of the
gyroscope (1) is located on the right side of the receiver/
controller component (2).
You can make these adjustments using a small screwdriver.
The further you turn the adjuster to the right, the stronger
the corrections (speed differences of the two rotors).
If the adjuster is turned too far towards the right, the heli-
copter will tend to show oscillating movements around the
yaw axis (rotor shaft). In this case, turn the adjuster a little
bit towards the left again.
b) Adjusting the Rotor Blade Linkage
The top rotor is controlled automatically via a paddle rod
with centrifugal weight (1).
Setup work on this part is not required and not intended.
46
Figure 17
Figure 18