Ingersoll Rand SSR UP5-4 Manuel D'utilisation Et D'entretien page 33

OPeRATIOn AnD MAInTenAnCe MAnUAL
Standard voltage
Full load current (maximum)
Starting current DOL (Star Delta)
Starting time DOL (Star Delta)
Starts per hour (maximum)
Control voltage
Recommended fuse rating See note 1
Recommended wire size AWG See note 2
eLeCTRICAL DATA-UP6 7.5
Standard voltage
Full load current (maximum)
Starting current DOL (Star Delta)
Starting time DOL (Star Delta)
Starts per hour (maximum)
Control voltage
Recommended fuse rating See note 1
Recommended wire size AWG See note 2
eLeCTRICAL DATA-UP6 10
Standard voltage
Full load current (maximum)
Starting current DOL (Star Delta)
Starting time DOL (Star Delta)
Starts per hour (maximum)
Control voltage
Recommended fuse rating See note 1
Recommended wire size AWG See note 2
eLeCTRICAL DATA-UP6 15c
Standard voltage
Full load current (maximum)
Starting current DOL (Star Delta)
Starting time DOL (Star Delta)
Starts per hour (maximum)
Control voltage
Recommended fuse rating See note 1
Recommended wire size AWG See note 2
1. If a circuit breaker is selected it should only be a magnetic trip type, set above the anticipated starting current
of the machine, but below the maximum prospective fault current for the circuit. The circuit breaker or fuseable
disconnect must be capable of breaking the prospective fault current at its terminals.
2. PVC/PVC Type Calculated using the following
conditions:
i) PVC insulated cable, armoured, copper
conductors.
ii) Cable clipped to a wall, in free air.
iii) Ambient temperature of 0°C (10°F) and relative
humidity of 0%.
http://air.ingersollrand.com
20V/1PH 200V
2.5A 15.5A
- -
–5 Sec (–10 Sec)
0A 25A
 10
20V/1PH 200V
.1A 22.A
- -
–5 Sec (–10 Sec)
50A 5A
 
20V/1PH 200V
- 2.A
- -
–5 Sec (–10 Sec)
- 50A
- 
20V/1PH 200V
- .2A
- -
–5 Sec (–10 Sec)
- 5A
- 
iv) 20m (5ft) cable run.
v) Volt drop limited to –10% during starting, –%
during normal running.
vi) Protected by the circuit breaker listed above.
InSTALLATIOn / HAnDLInG
20V/PH 0V
1.5A .A
- -

120VAC
20A 10A
12 1
20V/PH 0V
1.A .A
- -

120VAC
5A 15A
10 1
20V/PH 0V
2.0A 1.0A
- -

120VAC
5A 20A
 12
20V/PH 0V
.A 1.A
- -

120VAC
5A 0A
 10
55V
5.A
-
A
1
55V
.A
-
12A
1
55V
10.A
-
15A
1
55V
15.1A
-
25A
10