System Status Messages; Error Messages - Dri-Eaz LGR i- Serie Guide D'utilisation

Masquer les pouces Voir aussi pour LGR i- Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SYSTEM STATUS MESSAGES

The table below is a summary of status and data messages produced by the i-Series dehumidifers. The left column shows
the messages that appear on the control panel display.
C O N T R O L P A N E L
M E S S A G E
UNIT ON 00 HRS
UNIT ON 00 HRS
DEFROST CYCLE
OFF
UNIT ON 00 HRS
POWER FAILURE>
HUMIDISTAT
INLET XXX°F
HI TEMP CYCLE
REMAINING 00 MIN
[display is blank]

ERROR MESSAGES

The table below shows error messages that the system may display. If the display shows an "ER" message, first unplug
the unit and then plug it back in. This may re-set the electronics, and if so, no further action is required. If the error
message reappears, try the solution shown under "Explanation." If this still does not fix the problem, contact your local
authorized service center or the Dri-Eaz Service Department at 800-932-3030.
C O N T R O L P A N E L
M E S S A G E
ER1 CONTACT SERVICE
CENTER
ER2 CONTACT SERVICE
CENTER
ER3 CONTACT SERVICE
CENTER
ER4 √ DEFROST SENSOR
CONNECT
– or –
ER4 √ OUTLET SENSOR
CONNECT
07-01674J F410, F411
Normal operation.
Normal operation. Unit is in defrost mode. No action required.
Unit is turned off. AC power present.
Unit experienced a power failure but has successfully restarted. Press > to clear
this message.
Humidistat mode is active and dehumidifier energized.
LGR 2800i only. Indicates normal operation. Unit has detected higher ambient
temperatures and switched modes to operate more efficiently. No action required.
No AC power. Wireless transmitter functioning normally. No action required.
Check AC power for inadequate voltage. The electronic control panel may require
replacement. Contact service.
The electronic control panel may require replacement. Contact service.
Check defrost sensor for proper connection. Check sensor cable for damage.
Sensor assembly may need replacement. Contact service.
Check defrost sensor for proper connection. Check sensor cable for damage.
Sensor assembly may need replacement. Contact service.
8
E X P L A N A T I O N
E X P L A N A T I O N
Dri-Eaz Products, Inc.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Lgr 2800iLgr 3500i

Table des Matières