System Status And Data Messages; Error Messages - Dri-Eaz LGR 2800i F410 Mode D'emploi

SYSTEM STATUS AND DATA MESSAGES

The table below is a summary of status and data messages produced by the i-Series dehumidifers. The left column shows
the messages that appear on the control panel display. The center column shows the messages that are relayed to the
HygroTrac remote monitoring system and displayed on the HygroTrac website. The HygroTrac website will also display
one of three status messages for each i-Series unit detected by a HygroTrac gateway: S for standby (the unit is
disconnected from AC power but the wireless transmitter is working properly), A for active (the unit is sending normal data
and status messages), or I for inactive (the unit is sending no messages).
CONTROL PANEL
MESSAGE
UNIT ON 00 HRS
UNIT ON 00 HRS
DEFROST CYCLE
OFF
UNIT ON 00 FIRS
POWER FAILURE>
HUMIDISTAT
INLET XXX-F
HI TEMP CYCLE
REMAINING 00 MIN
[display is blankl

ERROR MESSAGES

The table below shows error message that the system may detect. If the display shows an "ER'' message, first unplug the
unit and then plug it back in This may re-set the electronics, and if so, no further action is required. If the error message
reappears. try the solution shown under 'Explanation. If this still does not fix the problem. contact your local authorized
service center or the Dri-Eaz Service Department at 800-932-3030.
CONTROL PANEL
MESSAGE
ER1 CONTACT SERVICE
CENTER
re ER2 CONTACT SERVICE
0
CENTER
IX
ix
w
2
ER3 CONTACT SERVICE
Ui
1--
CENTER
cn
›-
07
ER4 . DEFROST SENSOR
CONNECT
—
Or —
\
ER4 OUTLET SENSOR
CONNECT
141 Kirderkarnack Rd
Park Ridge, NJ
.
HYGROTRAC
WEBSITE MESSAGE
Dehumidifier On
In Defrost Mode
Dehumidifier Off AC power
present.
Dehumidifier Restarted after
Power Failure
Hunnidistat Controlled
In High Temp mode
Stand-by Mode,
HYGROTRAC
WEBS1TE MESSAGE
Failure: Contact Service
Center
Failure: Contact Service
Center
Failure: Contact Service
Center
Check Sensor Connections
Air Marketing Group ELC
07656
Tel. 201-782-1782 Fax. 201-782-1783 Web www arngair corn Email: info@amgair corn
EXPLANATION
Normal operation.
Normal operation. Unit is in defrost mode. No
action required.
Unit is turned off. AC power present.
Unit experienced a power failure but has
successfully restarted.
Humidistat mode is active and dehumidifier
energized.
LGR 2800i only. Normal operation. Unit has
detected higher ambient temperatures and
switched modes to operate more efficiently. No
action required.
No AC power. Wireless transmitter functioning
11.
action
normally. No required.
EXPLANATION
Cher* AC power for inadequate voltage. The
electronic control panel may require replacement.
Contact service.
The electronic control panel may require
replacement. Contact service.
Check defrost sensor for proper connection.
Check sensor cable for damage. Sensor assem-
bly may need replacement. Contact service.
Check defrost sensor for proper connection.
Check sensor cable for damage. Sensor assenn-
bly may need replacement. Contact service.