Using The Remote Control - Panasonic PV-GS9 Mode D'emploi

The Remote Control
Inserting the Button-type Battery
Before using the Remote Control, insert the supplied
button-type battery.
1 While pressing the Lock Button
the Battery Holder. Then, remove the
button-type battery.
2 Insert the button-type battery with the (+)
marking facing upward.
3 Insert the Battery Holder into the Remote
Control.
• When the button-type battery is exhausted, replace
it with a new CR2025 battery. (A battery is normally
expected to last about 1 year. However, it depends
on operation frequency.)
• Make sure to match the poles correctly when
inserting the button-type battery.
WARNING
● Replace Battery with Panasonic type
CR2025 only. Use of another battery may
present a risk of fi re or explosion.
● Battery may explode if mistreated.
● As with any small object, this type of Battery
can be swallowed by young children. Do not
allow children to handle this Battery.
CAUTION
● Dispose of used battery promptly.
● Do not recharge, disassemble or dispose of
in fi re.
Before Use
, pull out
1
1

Using the Remote Control

1 Direct the Remote Control at the Remote
Control Sensor of the Camcorder and
31
press an appropriate button.
15°
15°
15°
15°
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical and
horizontal directions from the central axis
• The above operating ranges are for indoor use
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously, they
can be operated individually by selecting different
Remote Control Modes.
• If the Remote Control Mode of the Camcorder and
that of the Remote Control do not match, [CHECK
REMOTE MODE (REMOTE)] Indication is displayed.
Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Control Mode. (p. 21)
Setup on the Remote Control:
2
[VCR1]:
Press the [ ] Button and [
simultaneously.
1
[VCR2]:
Press the [ ] Button and [
simultaneously.
2
• When the battery in the Remote Control is replaced,
the mode is automatically reset to [VCR1] Mode.
31
1
] Button
] Button
15