Front Pto; Hydraulic Lift; Controlled Position And Draft Hydraulic Lifts - GOLDONI 30HST TS24 Emploi Et Entretien

The central PTO can be engage independently from the rear PTO.

4.8.2 Front PTO

(optional)
The front PTO is engaged with knob n.14 fig.1:
• Set the engine Rpm at less than 1800 Rpm.
• Press knob n.14 fig.1 and turn it clockwise.
The front PTO is automatically disengaged by pressing knob n.14.
Spline: 1" 3/8 ASAE 6-spline
Turning direction: counter-clockwise
As an alternative, one of the following ratios can be installed on the tractor:
Speed: 1000 Rpm with engine at 2588 Rpm
Speed: 1600 Rpm with engine at 2226 Rpm'
Speed: 2000 Rpm with engine at 2692 Rpm.

4.9 HYDRAULIC LIFT

To operate the lift, use switch n.22 fig.1 while holding down the button on the top
and using the front switch lever.
When the lever is lowered, the lift lowers and stays in its floating position. When
the lever is raised, the lift raises to the required position.
The 3-point hitch must NOT be used to pull implements.

4.9.1 CONTROLLED POSITION AND DRAFT HYDRAULIC LIFTS

(optional)
The tractor can be equipped with a controlled position and controlled draft
hydraulic lift.
The operations described below are common to both kinds of lifts unless
otherwise indicated.
The following functions are possible:
• Raise and lower with floating function.
• Controlled position.
• Controlled draft (only with the controlled draft version).
• Combined (only with the controlled draft version).
The information and control sequences described here refer to fig. 9 where:
- P Controlled position potentiometer
80