Safety Belts (Where Applicable); Maintenance, Cleaning And Lubrication; Engine; Greasing - GOLDONI 30HST TS24 Emploi Et Entretien

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 42
When in the horizontal position, the safety frame will provide no
protection if the tractor tips up. When working in these conditions,
it is of the utmost importance for the operator to pay the greatest attention
when manoeuvring the machine.

5.2 SAFETY BELTS (where applicable)

Wear the safety belts when you use the machine with the safety frame (roll-bar
or ROPS) to reduce the risk of accidents if the tractor tips up.
Do not wear the seat belt if you use the machine with the roll-bar
in the horizontal position.

6. MAINTENANCE, CLEANING AND LUBRICATION

6.1 ENGINE

Refer to the Engine Instruction Manual.

6.2 GREASING

Every 50 hours, grease the points indicated in fig.7:
n.1 Front axle ball joint (2 grease nipples).
n.2 king pins (2 grease nipples: right and left)
It is advisable to use AGIP LP2 grease.

6.3 OIL SUPPLIES

6.3.1Gearbox casing and hydraulic lift

Every 50 hours check the oil level through plug and dipstick n.33 fig.1.
It is advisable to use AGIP SUPER TRACTOR UNIVERSAL SAE 15W/40 oil.
Change the oil every 800 hours. Amount needed: 17 kg approx.
Oil drain: plug n.1 fig.8.
Oil filler plug: n.19 fig.1.
Keep the oil vent plug clean. It is on the lift casing under the seat.
6.3.2.1 Cleaning the hydraulic fluid oil filter
The filter should be cleaned every 400 hours; whenever the oil is changed and
whenever the filter clog warning light comes on n.7 fig.2.
Drain the oil, remove the filter which is under the rear right hub. Wash the filter
with petrol or diesel fuel. Dry completely and replace in its seating. Clean the
filter after the first 50 hours.
86

Publicité

Table des Matières
loading

Table des Matières