Commissioning; Danger; Controls And Safety Features; Controls - JAC Diviform Notice D'utilisation Originale

Ensure first of all (after verifying electrical compatibility) that the motor is rotating in the right direction,
if so, the head will rise when you pull the control lever towards you. If this is not the case, disconnect
the plug and switch 2 phases in it.
FULLMATIC OPTION: When the power is switched on, the green button flashes; press to start
initialisation. If the head does not rise during this stage and the indicator flashes rapidly, disconnect
the plug and switch 2 phases in it.
For machine operation, please refer to the "Operation" chapter
5.5

Commissioning:

Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
For machine operation, please refer to the "Operation" chapter.
5.6

Danger:

If the user or the machine is in danger, you must use the main isolator switch to cut the power supply
to the machine.
Remove the plug from the power socket before any maintenance and/or servicing work.
Any maintenance work or replacement of parts must be carried out by an approved agent.
6

CONTROLS AND SAFETY FEATURES

6.1

Controls:

(fig.2)
Your machine is equipped as standard with a mechanical control panel (fig.2).
6.2

Work area:

The pressure setting area is on the right-hand side of the machine (DIVIFORM+) (fig.6, n°13).
FULLMATIC OPTION: the pressure time setting area and the half tank/full tank selector is located at
the front of the machine (fig.2)
6.3

Safety features:

The work area is at the front of the machine (fig.3, n°12).
English
10