Assembly Of The Combination; Installing The Strap Rolls; Initial Start Up; Application - Intimus 16.86 SmartShred Instructions D'opération

GB

2 .3 Assembly of the combination

1 . Push the baler under the shredder. Screw the shredder
and the baler together with the aid of the two fixing
brackets (fig. 2/7) provided with the shredder (fig. 1).
2 . Secure the end of the chain of the baler safety switch ac-
tivator (fig. 4/1) to the cross beam (fig. 4/2) of the shred-
der base, using the appropriate bores.
1 Safety switch activator
2
Dividing panel
fig. 4 Safety switch activator
3 . Insert the actuator (special key) of the safety switch acti-
vator (fig. 4/1) in the limit switch at the baler.
4 . Insert and secure the connecting plug of the baler in the
electrical outlet (fig. 1/4) at the housing rear panel.

2 .4 Installing the strap rolls

Remove the strap rolls (fig. 5/2), the strap roll holder (fig. 5/1)
and accessories (strap lifter, pull cable and screws) from the
baling chamber and insert the strap roll holder into the cor-
responding opening in the baler as shown. Place the left
and right-hand strap rolls onto the strap roll holder with the
strap ends pointing down.
The remainder of the procedure is described at „Baler ope-
ration", p. 23, under the heading "Replacing the strap rolls"
and "Inserting the straps for a new bale".
3
2
1 Strap roll holder
2
Strap roll
3
Dividing panel
4 Switch cabinet
fig. 5 Strap rolls
18
1 2
4
1
3

Initial start up

3 .1 Application

CAUTION!
Risk of injury! Damage to the cutting mecha-
nism!
The shredder should only be fed with paper or
cardboard!
Shredding other data carriers can cause
injury(e.g. by splintering of hard materials) or
may damage the shredder (e.g. destruction of
the cutting system).
The 16 .86 shredder/baler combination is a large-scale
shredding system for the shredding and baling of large vo-
lumes of paper.
The system shreds cardboard and crumpled paper just as
000205
easily as it does flat paper.

3 .2 Power supply connection

• The maximum value for loop impedance at the mains
connection point is 0.5 Ohms.
• The conductor cross-section of the power supply line
should be of a magnitude so as to cause a 15% voltage
drop in the case of a machine blockage (inhibit current
= 6 x nominal current).

3 .3 Checking the running direction

1
1 Emergency-stop bar
fig. 6 Emergency-stop bar
1 . Free the emergency-stop bar (pull out the bar) (fig. 6)
on the shredder feed table. Switch on the main switch
(fig. 7/2) i.e. to position „1".
2 . Turn the key selector switch (fig. 7/1) to the right.
000133
¾ The display appears.
3 . Press the green start button (fig. 7/3).
4 . Check that the shredder is running in the correct direc-
tion and correct the phase relation at the control box if
necessary.
Now that everything has been correctly assembled and con-
nected, you can proceed to operating the machine.
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
000206
94710 1 02/18