Intimus 16.86 SmartShred Instructions D'opération page 20

GB
Start screen (fig . 8)
The start screen appears when:
• the main switch is switched on and
• the key selector switch (fig. 7/1) is in the middle position.
1
1
Select language
2 Set the date and time
3 Settings for service technicians
fig. 8 Start screen
"Date – Time" screen (fig . 9)
The date and time are set from the start screen.
By default, the displayed date and time values are taken
from the control unit.
These values can also be set manually.
If necessary, the displayed values can also be synchronised
with those of the control unit.
1
2
3
1
Value taken from the control unit
2 Set the date and time manually
3 Apply the manually entered values
4
Synchronise the time and date with the control unit
5
Back button
fig. 9 "Date – Time" screen
20
2
3
000120
4 5
000121
Translation of the Original Operation Manual
Übersetzung der Originalbetriebsanleitung
"Automatic mode" main screen (fig . 10)
The "Automatic mode" screen appears when:
• the main switch is switched on and
• the key selector switch is turned to the right.
1
2
3
4 5
1
Illuminated display "Forward"
2
Illuminated display "Backward"
3 Illuminated display „Ram at rear"
4
Illuminated display „Bale ready"
5
Illuminated display "Oil cutting mechanism" — optional
6
Illuminated display "Conveyor belt running" — optional
Illuminated display "Extraction system running" — opti-
7
onal
8 Total operating hours, operating hours since last service
and number of blockages
fig. 10 "Automatic mode" screen
"Manual operation" main screen (fig . 11)
The „Manual operation" screen appears when:
• the main switch is switched on and
• the key selector switch is turned to the left.
1 Button "Cutting mechanism: forward operation"
2 Button "Cutting mechanism: backward operation"
fig. 11 „Manual operation" screen
The machine and conveyor belt will continue running for as
long as the button is pressed.
8
6 7
000134
1
2
000123
94710 1 02/18