Baler Operation; Using The Baler; Feeding The Baler Via The Shredder; Feeding The Baler Manually - Intimus 16.86 SmartShred Instructions D'opération

GB
6

Baler operation

6 .1 Using the baler

The strap brake (fig. 14) must be closed (move lever to right).
1 Strap brake
fig. 14 Strap brake
NOTE!
If baling is to be performed without subsequent ty-
ing off, refer to "C) Eject into plastic sack without
tying off".
6 .2 Feeding the baler via the shred-
der
When the baling chamber and the inlet funnel are filled with
material from the shredder, the compacting cycle is started:
The baling ram (fig. 13/1) advances, compacts the material
and then returns to home position. The shredder may be fed
while the baler is compacting.

6 .3 Feeding the baler manually

CAUTION!
Danger of explosion! Risk of injury!
Do not compact aerosol containers such as
spray cans etc.
Non-confidential materials can also be fed manually to the
baler. Return the baling ram to its rear, home position if ne-
cessary (close the inlet flap and press the "Return Ram" key
(fig. 12/3)) and proceed as follows:
1 . Open the inlet flap (fig. 1/5).
2 . Insert material into the baling chamber.
3 . Close the inlet flap and activate the „Advance Ram" Key
(fig. 12/1).
¾ The baling ram travels forwards (compacting cycle)
and, when the compaction procedure is complete,
returns to its home position. Feeding may now be
continued.
94710 1 02/18
1
1
000207

6 .4 Completing the bale

When, after several compacting cycles, the baling ram
(fig. 13/1) no longer returns to home position, but rather re-
mains pressed against the bale, maximum bale volume has
been reached. The bale must be tied off and ejected. A horn
sounds to indicate this.
Confirm the „bale ready" mode by operating the red „Stop
button", (fig. 7/5). The horn stops.
NOTE!
The shredder cannot be started while the bale is
being tied off and ejected (inlet and discharge flaps
are open).
The bale can be ejected in three different ways, and then
removed.
A) Tie off and eject into plastic sack (for small particles)
(fig. 9, 10, 11, 12 and 13)
B) Tie off and eject without plastic sack (for large partic-
les) (fig. 9, 10 and 12)
C) Eject into plastic sack without tying off (for small par-
ticles) (fig. 11 and 13)
NOTE!
Suitable sacks and straps can be ordered at any
time (see „Accessories", p. 27).
Tying off the bale
1 . Open the inlet flap (fig. 17/3).
2 . Open the strap brake (fig. 14/1).
3 . Pull the straps to approximately 40 cm above the baling
ram with the help of the strap lifters (fig. 15/2) and the
included strap hook.
1
1
Strap hook
2
Strap lifter
fig. 15 Strap lifters
4 . Firmly hold the straps and return the strap lifters to their
original position.
5 . Loosen the strap ends (fig. 20/3) which have been se-
cured to the baler housing, knot them together with
the respective straps pulled out in the preceding step
(fig. 16) and cut the strap behind the knot with a pair of
scissors.
16.86 SmartShred
2
000136
23