Inserting Straps For A New Bale; Replacing The Strap Rolls - Intimus 16.86 SmartShred Instructions D'opération

GB
1 Sack frame
fig. 19 Installing a new plastic sack
1 . Open the discharge flap and return the baling ram to its
rear, home position. The inlet flap remains closed.
2 . Push the sack bit by bit over the sack frame (fig. 19) until
the entire sack has been mounted to the frame.
3 . Close the discharge flap.

6 .7 Inserting straps for a new bale

1 . Return the baling ram to home position by pressing the
"Return Ram" key (fig. 12/3).
NOTE!
This is only possible in inching operation when the
discharge flap is open.
2 . Open the inlet flap.
3 . Pull the straps out a distance equivalent to about one
flap length, guide the strap ends from the inside over
the strap hook (fig. 20/1+2), through the inlet opening
and up to the strap clamps (fig. 20/3). Secure the strap
ends here by wrapping them twice around the clamps.
1
2
1 Upper strap hook
2 Strap hook at the bottom
3 Strap clamps
fig. 20 Inserting straps for a new bale
4 . Close the strap brake (fig. 14).
NOTE!
In order to allow for subsequent tying off of the
bale, the strap brake must be closed before the
compacting cycle.
94710 1 02/18
1
000041
1
2
3
000140
5 . Close the discharge flap (fig. 17/1), as well as the inlet
flap (fig. 17/3), if the shredder is to be used.
NOTE!
In order to avoid damage to the straps, it is advisab-
le to refrain from compacting bottles, glass or other
objects with sharp edges such as sheet metal etc.

6 .8 Replacing the strap rolls

1 Strap lifter
2 Guide for strap lifter
fig. 21 Strap lifter
1 . Close the inlet flap and advance the baling ram about
30 cm.
2 . Open the inlet flap and remove both strap lifters
(fig. 21/1).
3 . Open the strap brake (fig. 14).
4 . Insert the strap rolls (fig. 22/2) in to the strap roll holder
(fig. 22/1) as shown, with the strap ends pointing down.
5 . Secure the strap end to the loop on the included pull
cable and feed the other end of the pull cable (fig. 22/4)
through the opening at the strap brake (fig. 22/5) and
into the strap guide (fig. 22/3). The strap can now be
pulled through the strap guide with the pull cable, until
it is visible within the baling chamber.
6 . Loosen the strap end from the pull cable as shown, feed
it through the strap lifter (fig. 21/1) and set the strap lif-
ter back into place at the baling ram (fig. 21/2).
7 . Insert both straps as described under „Inserting straps for
a new bale", p. 25 and close the strap brake (fig. 22/5).
8 . Close the discharge and the inlet flaps and return the
baling ram to its rear, home position.
16.86 SmartShred
1
000141
2
25