Operating Elements Baler; Emergency Stop Bar - Intimus 16.86 SmartShred Instructions D'opération

GB

4 .3 Operating elements baler

1
1 „Advance Ram" Key
„Stop Ram"or "Open Discharge Flap"
2
3 „Return Ram" Key
fig. 12 Operating elements baler
1 = „Advance Ram" Key (compacting cycle)
If this key is pressed, the baling ram (fig. 13/1) is ad-
vanced (compacting cycle) and is then automatically
retuned to its rear, home position.
NOTE!
If the ram does not return to its home position, but
rather continues to press against the bale, the bale
must be tied off and then ejected (see „Completing
the bale", p. 23).
2 = Key
a) Stop Ram
If this key is activated briefly (less than 2 seconds),
the baling ram (fig. 13/1) is stopped.
b) Open Discharge Flap
If the key is pressed and held (for at least 2 seconds),
the baling ram travels a short distance in reverse and
the locking lever (fig. 17/2) is advanced a short dis-
tance (pressure relief at the discharge flap).
The discharge flap (fig. 17/1) can now be opened.
This is necessary when the baler is holding the bale
in the compacted condition.
NOTE!
The discharge flap can only be opened after this
key (fig. 12/2) has been activated.
3 = „Return Ram" Key (return stroke) (fig . 8)
When this key is activated in the automatic operating
mode, the baling ram (fig. 13/1) is returned to its rear,
home position.
94710 1 02/18
2 3
000036
1
Baling ram in home position
2
Sack frame
fig. 13 Baler

4 .4 Emergency stop bar

(fig . 6/1)
Should it be necessary, for any reason, to switch off or stop
the machine as quickly as possible, this can be achieved by
pressing the emergency stop bar. To switch on again, re-
lease the bar (pull it out) and operate the green „Start but-
ton" (fig. 7/3).
16.86 SmartShred
1 2
000037
21