Technical Data; Transportation; Transportation In Vehicle; Painting Material Setup - Titan Performance 1650e Série Mode D'emploi

Description of unit
3.5

Technical data

Voltage:
Max. current consumption:
Power cord:
Acceptance capacity:
Max. operating pressure:
Volume flow at 12 MPa
(120 bar) with water:
Max tip size:
Max. temperature of the
coating material:
Max viscosity:
Weight:
Special high-pressure hose: DN 6 mm, 15 m, connection
Dimensions (L X W X H):
Max sound pressure level:
* Place of measuring: 1 m in distance from the unit and 1.6
m above the floor, 12 MPa (120 bar) operating pressure,
reverberant floor.
3.6

Transportation

Pushing or pulling the unit
Pull out the handle (Fig. 2, Item 1) until it will come no further.
Insert the handle – push the buttons (2) on the spars, and then
push in the handle.
2
3.7

Transportation in vehicle

Secure the unit with a suitable fastening.
220-240 Volt AC, 50/60 Hz
9.5 A @ 230VAC
3 x 1.5 mm – 6 m
2
1650 Watt
221 bar (22,1 MPa)
5.0 l/min
0.039 inch – 0.99 mm
43°C
30.000 MPa·s
50 kg
thread M 16 x 1.5
632 x 568 x 743 mm
80 dB (A) *
1
2
GB
3.8 Paint material setup
i
This sprayer comes with a filter assembly
installed. If you plan to spray with untextured
painting materials, leave the filter installed.
3.9

Textured material setup

This sprayer comes with a filter plug that should
i
be put in place of the filter whenever spraying
textured materials. Follow these steps to remove
the filter and install the plug.
1. Loosen and remove the filter housing (1) by hand.
2. Remove the adapter spring (2), filter (3), bearing ring (4)
and spring (5) from the housing (7).
3. Make sure the O-ring (6) is still in place. Thread the filter
plug (8) into the housing until secure.
i
The filter plug should be hand-tightened, but
make sure it is seated fully into the filter housing.
1
2
3
4
5
i
If using this sprayer with textured materials, it is
important that the filter inside of the spray gun
be removed. See section 8.3.
If the sprayer will be used for spraying textured
i
products, removal of the inlet screen in the foot
valve may be necessary. This will allow proper
priming and flow of the textured product. See
section 8.4.
26
8
6
7
Performance Series 1650e