Packings - Titan Performance 1650e Série Mode D'emploi

13. Remove the upper support ring (9) and upper packing
assembly (10) from the top of the upper housing (2).
14. Remove the adapter (11) and lower packing assembly
(12) from the bottom of the upper housing.
Be careful not to scratch, score, or otherwise
damage the upper housing during removal of the

packings.

8
9
10
7
2
12
11
6
15. Clean the upper housing (2) and cylinder (3-5). Inspect
the upper housing and cylinder for damage and replace if
necessary.
16. Place the upper housing upright (2) in a vise by clamping
on the wrench flats (7).
17. Locate the new upper and lower packings and remove the
pre-form tools. Save the upper packing pre-form tool for
use as the piston insertion tool later in this procedure.
Do not remove the pre-form tools from the upper
i
and lower packings until immediately before they
are installed into the upper housing.
Performance Series 1650e
GB
18. Lubricate upper packing (10) and lower packing (12) with
19. Insert upper packing (Fig. 21) with O-ring (1) and
20. Insert upper support ring (9) on top of the upper packing
21. Thread the upper seal retainer (8) into the upper housing
22. Rotate the upper housing in the vise so that the bottom
23. Insert the lower packing (Fig. 22) partially into the bottom
14
13
1
24. Push the lower packing assembly (Fig. 20, Item 12) into
3
4 i
5
25. Place the piston insertion tool over the top of the piston
26. Insert the piston rod (6) into the bottom of the upper
i
27. Remove the piston insertion tool from the top of the piston
28. Lubricate the threads on the upper housing with anti-seize
29. Insert the piston rod into the extension slider. When the
30. Thread the upper housing into the cylinder, turning
31. Continue to turn the upper housing clockwise until it is
32. Replace the cylinder (3) back into the fluid section clamp
33. Push the lever on the underside of the unit toward the rear
34. Insert the adapter (Fig. 20, item 11) into the bottom of the
37
machine grease.
protruding lip (2) downward.
1
2
(10)
(2).
end is facing up.
of the cylinder with the large beveled edge (1) facing
toward the cylinder (beveled edge will be facing up when
the cylinder is upright).
1
position using the lower packing insertion tool (see Fluid
Section Assembly parts list for lower packing insertion tool
P/N).
Coat the piston insertion tool (i.e. upper packing
pre-form tool) and the piston rod with grease
before inserting them into the upper housing.
rod (6).
housing (2), through the lower packing assembly (12),
through the upper packing assembly (10), and out through
the upper seal retainer (8).
Make sure the raised lip on the bottom of the
lower packing is fully outside the packing around
the piston rod after insertion of the piston rod.
rod (6).
compound. Remove the upper housing from the vise.
connecting pin hole on the piston rod lines up with the hole
in the extension slider, insert the connecting pin.
clockwise.
flush against the cylinder.
on the gear housing. Make sure to slide the top of the
piston rod extension into the T-slot (13) on the slider
assembly (14).
of the sprayer to lock the fluid section back into place.
upper housing.
Repairs at the unit