Cleaning, Disinfecting And Sterilizing - Ultradent Products ultrawave J58349 Manuel De L'utilisateur

Immunity test
Handheld and mobile radiofrequency communication devices must not be used near the device (including cables) at a
distance below that recommended and calculated according to the frequency and power of the transmitter.
Radiated radiofrequency
electromagnetic field
(IEC61000-4-3)
Radiofrequency conducted
disturbance (IEC61000-4-6)
The electromagnetic field intensity of fixed radiofrequency transmitters, as determined by an electromagnetic
environment measurement (a), must be less than the conformity level for each frequency range (b). Interferences may
occur near the equipment identified by the following symbol:
Note 1: At 80 MHz and 800 MHz, the highest frequency range applies.
Note 2: These specifications cannot be applied to all situations. The electromagnetic propagation is
affected by the absorption and reflection of structures, objects and people.
(a) The electromagnetic field intensity of fixed radiofrequency transmitters, such as base stations for portable phones
(mobiles / wireless), mobile radios, radio amateurs, AM/FM radio transmissions and TV transmissions cannot be determined
accurately by the theory.
To assess the electromagnetic environment caused by fixed radiofrequency transmitters, an electromagnetic environment
measurement must be taken. If the measured intensity of the radiofrequency field in the
immediate product use environment exceeds the radiofrequency conformity level specified above, it is
necessary to test product performance to check this complies with specifications. If abnormal performance is observed,
additional measures may be necessary, such as changing the direction of or moving the product. (b) In the 150 kHz to
80 Mhz frequency range, the electromagnetic fields must be less than 3 V/m.
6 Cleaning, disinfecting and
sterilizing
12
Test level
3 V/m
80 MHz to 2.5 GHz
3 V/m
150KHz to 80MHz
J00039 • V3 • (13) • 12/2013 • RB77US030D
Conformity level
3 V/m
3 V/m
Electromagnetic
environment - comments
d = 1.2 √ P 80 MHz to 800 MHz
d = 2.3 √ P 800 MHz to 2.5 GHz
Where (P) is the maximum
nominal power of the
transmitter in Watts (W)
according to the
manufacturer specifications
and (d) is the minimum
recommended separation
distance in meters (m).
Recommended separation
distance: d = 1.2 √P