Siemens SITRANS TH Notice De Service page 24

4.9.4 Closing the device
Procedure
Note
Key cover
①
Key cover without function. Key cover is sealed in the factory.
④⑦
1. Screw the covers
2. Secure the covers with the cover catch
3. Check the tightness of the blanking plugs
①
Key cover
②
Cable bushing
③
Safety catch (back)
④
Cover (rear) for electrical terminal compartment
Figure 4-3 Device view - left: rear view, right: front view
5 Commissioning
5.1 Commissioning
Procedure
1. Program the transmitter's operating data according to the actual requirements.
If applicable, enter the changed operating data on the additional plate on the enclosure.
2. Assemble the transmitter.
3. Connect the sensor to the power supply, see Chapter "Power supply connection (Page 22)".
4. Turn on the auxiliary power supply.
5. Wait about 10 seconds. After this start-up time the transmitter is operational.
24
on as far as they will go.
③⑥
.
⑤
and cable gland
②
in accordance with the degree of protection.
⑤
Blanking plug
⑥
Safety catch (front)
⑦
Cover (front), optionally with inspection window
⑧
Safety catch for stainless steel enclosure
SITRANS TH/TR/TF
A5E32363963-02, 09/2021