Energy Label (Fig.3); Transport (Fig. 3); Receipt And First Cleaning; Installation And Environmental Conditions (Fig. 5) - Arneg Berlino 3 Manuel D'installation

Berlino 3
English

5. Energy label (Fig.3)

According to the EU Regulation 2019/2018 this product is a refrigeration appliance with a
direct sales function, therefore it must have an energy label.
The information on the label refers to precise configurations.
Any configuration other than the one presented could result in a significant change in the
energy class information. The energy class ranges from A to G, where A represents a very
efficient product with low energy consumption and G represents a product with lower
efficiency and higher energy consumption.
Below is an explanation of the information on the label:
I QR code, leads to the model values in EPREL
II supplier's trade mark or name
III supplier model identifier
IV energy efficiency class from A to G
V energy efficiency class, determined in accordance with Annex II
VI AE in kWh per year, rounded to the nearest integer
VII sum of the exposure surfaces at operating temperatures for refrigeration expressed in
square metres (m²) and rounded to two decimal places.
temperature range reached by the cooled products: at the top the maximum value of the
VIII
warmest product; at the bottom the minimum value of the coldest product
IX sum of the exposure surfaces at operating temperatures for freezing, expressed in square
metres (m²) and rounded to two decimal places
temperature range reached by frozen products: at the top the maximum value of the
X
warmest product; at the bottom the minimum of the highest value of all products
XI number of this regulation

6. Transport (Fig. 3)

The cabinets are supplied on a wooden support fixed to the base for movement with forklift trucks.
Always position the forks at the point specified on the wooden support to avoid the risk of
overturning. Use a manual or electrical forklift truck that is suitable to moving the cabinet in question.
It must have a nominal capacity of at least 1,000 kg.

7. Receipt and first cleaning

On receiving the cabinet:
- make sure that the packaging is integral and no evident damage is present;
- remove the packaging with care so as not to damage the cabinet;
- check all parts of the cabinet ensuring that its components are integral;
- if damaged, immediately call the supplier;
- use neutral products for a first cleaning of the cabinet. Dry with a soft cloth, do not use abrasive
substances or metallic sponges
- do not use alcohol or similar products for the methacrylate parts (plexiglass).
For a correct disposal of the packaging take into consideration that it consists of:
Wood - Polyester - Polythene - PVC - Cardboard.
In compliance with the EEC 94/62 directive the suitability of the materials stated above is declared.

8. Installation and environmental conditions (Fig. 5)

For installation, follow the instructions below:
- Do not position the cabinet:
- in places containing explosive gaseous substances;
- in the open air and, therefore, exposed to atmospheric agents;
- near sources of heat (direct sunlight, heating appliances, incandescent lights, etc.);
- near air currents (near doors, windows, air-conditioning systems, etc.) that should not exceed the
speed of 0.2 m/s.
- Remove the wooden supports on the base (used for transportation) and mount the adjustable feet
(Rif. 2) regulating them so as to position the cabinet horizontally; use a level (Rif. 1) to make sure of
its positioning.
- After moving the cabinet, check leveling.
- Remove the wooden protections located on the cabinet top.
32 05060070 03 05-2022