Transportation At Frost - Dibo JMB-S Mode D'emploi

5.6. Transport
5.6.1. General
- Before transport: empty water tank!
- Close the protection covers
- Attach the nose wheel carefully on the towing hook eye it is meant for it. This cable is a safety precaution
and is used as an emergency break, when suddenly the coupling gets loose during the drive.
- Attach the electrical cable for the lighting, and check it.
- Unbolt the overrun brake ( if present) and remove the wedge.
tions apply to your country.
The plate must be attached properly on the rear and in this way that the lighting lights the complete plate.

5.6.2. Transportation at frost

Add antifreeze to the water in the water supply tank, in order that the machine can suck this liquid. Get the
hose from the spray gun and turn on the machine. Spray until the antifreeze water comes out of the gun.
you get a closed circuit and no antifreeze liquid gets lost. Turn off the machine as described.
Antifreeze is an additive which may absolutely not been drain/discharged without permission.
You have to collect the outlet antifreeze water in a reservoir. This is also the case when you use the
Please do always take into account the matching security measures.
TIP: You can use the collected water with antifreeze several times !
Remark
(by loosening the basket and draining the water from the hose).
the high pressure hose (closed circuit). Put the cleaner on idle speed and operate the spray gun. Keep the
- 1.230.100/101/102).
DiBO n.v. 62
Low pressure coupling
Safety valve
High pressure coupling
-