Turn Off; General; Chemical Tank; Ecn With Chemicals Tank - Dibo ECN Mode D'emploi

5. Turn off

5.1. General

Put the main switch on 0: OFF when you finish the works.

5.2. Chemical tank

Pull the sucking hose out of the chemicals tank and hang it in a bucket with clean water. Seal the chemicals tank
with a cap. Rinse everything with clean water this to remove chemicals out off the hoses, lance and pistol.

5.3. ECN with chemicals tank

Rinse everything with clean water this to remove chemicals out off the hoses, lance and pistol.
Remove at the bottom, the run- dry cap to transport the dirty water out of the cleaner.
At a change of EVERY chemical product you have to rinse the tank again with clean water!

5.4. Lance and gun

Uncouple the lance and put it away. Close the water supply. Roll up the high and low pressure hoses.

5.5. Water outlet

See chapter 1 - safety and 2.1.2.

5.6. Put away machine

Clean when necessary the water filter. See that the machine is parked frost-proof.
Furthermore, it is recommended to empty the cleaner and accessories of water, or rinsing with antifreeze.
Press the wheel clip protections at the front side (at both wheels).
5.7. Environmentally safe disposal of used fluids
No fluids (anti-scale product, oil, ...) may be disposed randomly because of the environment!
So make sure, if you are user, that the applicable local guidelines for environmentally friendly disposal of these
fluids (without soil pollution) are complied.

5.8. Transport

Pay attention at transport to the following: keep the machine as much as possible horizontal during transport, one
prevents that there leaks oil from the pump. Load the machine using a lift truck, hydraulic loading platform or a
hoist. Lash the machines (if necessary) sound fixed on the loading platform.
Pay attention for ECN-XL (500/30): the charging/lifting of the unit must happen according to the photos like
mentioned below by means of the provided lifting shaft. This according to applying standards/directives and with
the correct lifting tools! Care for a uniform load distribution. Care that there's nobody in the neighbourhood of the
charge at lifting work activities! Leave a loaded charge never abandoned!
Check before use of the lifting shaft if these are corroded, damaged or has break.

5.9. Transportation at frost

Replace the water sucking hose by a short piece hose and hang it with his end in the anti-frost, so the machine
can suck in the anti-frost. Take the lance from the gun and operate the machine.
Spray until there comes anti-frost out of the gun. The machine is now filled with anti-frost, stop the machine.
Tip: Because the catch of the outgoing anti-frost water, this can be re-used afterwards.
ECN-M/T/L : REV 0 DiBO n.v. 54