Scope Of Application - Dibo JMB-S Mode D'emploi

LETTER
A Fuel level
B JMB operational
C Oil pressure
D Water temperature
E Dynamo
F NA
G Engine preheat
H
I NA
J Hours counter
4.5. Pumps HT
There must be present a pre - pressure (pump) at HT pumps (pumps with high temperature). The pre - pressure
cause damages. For all these applications at high temperature, it is ABSOLUTELY ESSENTIAL to feed the

4.6. Scope of application

Using cleaning products (if applicable): the surface to clean should be sprayed so the product can act during
some time (do not let it dry!) before cleaning with high pressure jet.
Cleaning agents can increase the cleaning effect if they are used correctly!
Always follow/consider the safety instructions of the used product!
Cold water (high pressure) cleaning: removal of (mild) impurities/pollution and rinsing.
Hot water (high pressure) cleaning (if applicable): the cleaning effect will be such improved through increasing
the temperature (set the temperature experimentally according to the application).
Cleaning via lance with rotating head (if applicable): cleaning method to remove tough layers of dirt.
Cleaning using a steam lance (if applicable): this steam function (by overheating water) is used in 'sensitive'
cleaning applications (eg: damage sensitive surfaces) where there is stubborn dirt (eg: degreaser) is removed by
using steam.
Please note: this application has high cleaning temperatures and requires various safety measures!
REFER TO
Indicates green as the engine is working, with status everything ok.
Indicates red as the key switch is put on, and it extinguish when the
motor is working. When the oil pressure is to low during operation, the
indicator lights on and the diesel engine will turn off.
Indicates red as the key switch is put on. The system is carrying out a
control and the indicator extinguish if the water temperature is good. If
the water temperature of the diesel engine is to high, this indicator will
light on and the engine will turn off.
Indicates red as the key switch is put on and extinguish when the dy-
namo delivers tension. When the dynamo delivers no tension while the
diesel engine is running, this indicator will light on.
Indicates red as the key switch is put on. The system is carrying out a
control and the indicator extinguish.
Indicates orange if the key switch is put on, and extinguish when the
diesel engine is preheated
Indicates red as the key switch is put on. The system is carrying out a
This indicator is not in use.
Here one can see the actual working hours of the machine.
DiBO n.v. 60
FUNCTION
-