Usage (Blood Pressure) - Beurer BM 96 Cardio Mode D'emploi

You can set 2 different alarm times to remind yourself to take the measurement. To set the alarm,
proceed as follows:
• Alarm 1 is shown in the display,
1
alarm 1 should be activated (
• If alarm 1 is deactivated (
• If alarm 1 is activated, the hours flash on the display. Select the desired hour using the function but-
tons / and confirm with M2. The minutes flash on the display.
• Select the desired minute using the function buttons / and confirm with M2.
• Alarm 2 is shown in the display,
2
• To set, proceed as for alarm 1.
You can either turn on or turn off Bluetooth
• Use the / function buttons to choose whether automatic Bluetooth
(Bluetooth ® lights up,
• Confirm your setting with pressing the M2 button.
Bluetooth ®
You can choose between four different ECG measurement times (30 seconds, 60 seconds, 90 sec-
onds and 120 seconds). To set the ECG measurement time, proceed as follows:
• Select the desired ECG measurement time using the function buttons / and confirm with M2.
• The blood pressure monitor switches itself off automatically.

7. Usage (blood pressure)

General rules when measuring blood pressure yourself
• In order to generate as informative a profile of the progression of your blood pressure as possible and
ensure that the measured values can be compared, you should measure your blood pressure regularly
and always at the same times of day. It is recommended that you measure your blood pressure twice a
day: once in the morning after getting up and once in the evening.
• You should always carry out the measurement when you are sufficiently physically rested. You should
therefore avoid taking measurements during stressful periods.
• Do not take a measurement within 30 minutes of eating, drinking, smoking or exercising.
• Before the initial blood pressure measurement, make sure always to rest for 5 minutes.
• Furthermore, if you want to take several measurements in succession, make sure always to wait for at
least 1 minute between the individual measurements.
• Repeat the measurement if you are unsure of the measured value.
• Place the cuff on your upper arm only. Do not place the cuff on other parts of the body.
flashes) or deactivated (
), you automatically switch to setting alarm 2.
flashes) or deactivated (Bluetooth
transfers will reduce the battery life.
or flashes. With the function buttons / , choose whether
or off flashes.
® . To make the settings, proceed as follows:
47
flashes) and confirm with M2.
® data transfer is activated
® lights up, flashes).