Points To Note When Setting Up The Compressor - EINHELL EURO 2500-1 Mode D'emploi

Anleitung Euro 2500-1 Einhell
GB
Read this manual carefully before putting the compressor into operation!
Technical data
Power supply
Motor rating in kW/h.p.
Compressor speed in rpm
Operating pressure in bar
Pressure vessel volume in litre
Theoretical intake rate in l/min.
Sound power level LWA in dB(A)
Sound pressure level LPA in dB(A)
Protection type
Machine weight in kg
Art.-Nr.:
I-Nr.
The machine is radio-suppressed in accordance with EC Guidelines 82/499 EEC.
The unit is not intended for outdoor operation as per Article 3 of EC Directive 2000/14/EC.
Points to note when The complete compressor has
setting up the undergone an official prototype
compressor test. The machine can be put
into operation without further
testing by a technical inspector
Examine the machine for signs
(e.g. TÜV). It is important to
of transit damage. Report any
keep the supplied factory
damage immediately to the
certificate and test certificate in
company which delivered the
a safe place.
compressor.
The above mentioned
Before you put the compressor
certificates have to be
into operation, check the oil
presented on request to
level in the compressor pump.
representatives of your factory
The compressor should be set
inspectorate. In this connection
up near the working consumer.
see also the manufacturer's
Avoid long air lines and long
certificate „Notes for the user".
supply lines (extensions).
Make sure the intake air is dry
Safety instructions for
and dust-free.
working with com-
Do not set up the compressor
pressed air and paint
in damp or wet rooms.
sprayers
The compressor may only be
used in suitable rooms (with
Important! Note the pertinent
good ventilation and an
accident prevent regulations in
ambient temperature from +5°
force in your area!
to +40°C). There must be no
dust, acids, vapors, explosive
Compressors and lines reach
gases or inflammable gases in
high temperatures during
the room.
operation. Avoid contact! Risk of
The compressor is designed to
burns!
be used in dry rooms. It is
prohibited to use the
Gases or vapours drawn in by the
compressor in areas where
compressor have to be kept free
work is conducted with sprayed
of constituents that may cause
water.
fire or explosions inside the
10
21.07.2003 7:15 Uhr Seite 10
EURO 2500-1
230 V ~ 50 Hz
1,5 / 2
2850
8
50
210
97
87
IP 20
39
40.101.10
01033
compressor.
When you disconnect the hose
coupling, hold the coupling
element in your hand to prevent
injury from the whiplashing hose.
Wear goggles when working with
the blow-out gun. Injuries may
easily result from foreign bodies
and blasted parts.
Never point the blow-out gun at
other persons and never use it to
clean clothes that are still being
worn.
Note the safety
instructions for paint
spraying!
Important! Note the pertinent
accident prevent regulations in
force in your area!
Never process paints or
solvents with a flash point
below 21°C.
Never heat paints or solvents.
It is imperative to use filtering
equipment (face masks) when
processing harmful liquids.
Note also the information
concerning safety precautions
published by the manufacturers
of these liquids.