Technical Data; Assembly And Starting; Before Starting The Equipment; Setting The Pressure Switch - EINHELL TH-AC 190/6 OF Mode D'emploi D'origine

4. Technical data

Power supply: .................................... 230 ~ 50 Hz
Motor rating in kW: .......................................... 1.1
Operating mode .......................... S3 25% 10 min
Compressor speed in rpm: ........................... 3550
Operating pressure in bar: ................................. 8
Pressure vessel volume in litre: .......................... 6
Theoretical intake rate in l/min.: ...................... 185
Sound power level L
WA
K uncertainty ............................................. 2 dB
WA
Sound pressure level L
K uncertainty ............................................. 2 dB
pA
Protection type: ............................................ IP 20
Machine weight in kg: ......................................... 9
Noise
The noise emission values were measured in ac-
cordance with EN ISO 3744.

5. Before starting the equipment

Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
•
Examine the machine for signs of transit da-
mage. Report any damage immediately to the
company which delivered the compressor.
•
The compressor should be set up near the
working consumer.
•
Avoid long air lines and long supply lines (ex-
tensions).
•
Make sure the intake air is dry and dust-free.
•
Do not set up the compressor in damp or wet
rooms.
•
The compressor may only be used in suitable
rooms (with good ventilation and an ambient
temperature from +5°C to +40°C). There must
be no dust, acids, vapors, explosive gases or
inflammable gases in the room.
•
The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor
in areas where work is conducted with spray-
ed water.
Anl_TH_AC_190_6_OF_SPK7.indb 15 Anl_TH_AC_190_6_OF_SPK7.indb 15
GB
in dB: ............................ 97
in dB: ........................ 75
pA
- 15 -

6. Assembly and starting

Important!
You must fully assemble the appliance before
using it for the fi rst time.
6.1 Voltage
Before you use the machine, make sure that the
mains voltage complies with the specifi cations on
the rating plate. Long supply cables, extensions,
cable reels etc. cause a drop in voltage and can
impede motor start-up. In the case of low tempe-
ratures below +5°C, motor start-up is jeopardized
as a result of stiff ness.
6.2 On/Off switch (8)
To switch on the equipment set the On/Off switch
(8) to position 1.
Move the On/Off switch (8) to position 0 to switch
off the equipment.
6.3 Adjusting the pressure: (Fig. 1)
•
You can adjust the pressure on the pressure
gauge (6) using the pressure regulator (7).
•
The set pressure can be taken from the quick-
lock coupling (5).

6.4 Setting the pressure switch

The pressure switch is set at the factory.
Switch-on pressure 6 bar
Switch-off pressure 8 bar

7. Replacing the power cable

If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
17.12.12 14:34 17.12.12 14:34