Technical Data; Points To Note When Setting Up The Compressor - EINHELL EURO 4300 V Instructions De Service

Anl Euro 4300 V_SPK1 08.09.2006
The machine noise may exceed 85 dB(A) at the
workplace. In this case, noise protection
measures need to be introduced for the user.
Keep these safety instructions in a safe place.

Technical data

Power supply 230 V ~ 50 Hz
Motor rating in kW/h.p.
Compressor speed in rpm
Operating pressure in bar
Pressure vessel volume in litre
Theoretical intake rate in l/min.
Sound power level LWA in dB(A)
Sound pressure level LPA in dB(A)
Protection type
Machine weight in kg
Points to note when setting up the
compressor
● Examine the machine for signs of transit damage.
Report any damage immediately to the company
which delivered the compressor.
● Before you put the compressor into operation,
check the oil level in the compressor pump.
● The compressor should be set up near the
working consumer.
● Avoid long air lines and long supply lines
(extensions).
● Make sure the intake air is dry and dust-free.
● Do not set up the compressor in damp or wet
rooms.
● The compressor may only be used in suitable
rooms (with good ventilation and an ambient
temperature from +5° to +40°C). There must be no
dust, acids, vapors, explosive gases or
inflammable gases in the room.
● The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor in
areas where work is conducted with sprayed
water.
10:21 Uhr Seite 9
Safety instructions for working with
compressed air and paint sprayers
Important! Note the pertinent accident prevent
regulations in force in your area!
Compressors and lines reach high temperatures
during operation. Avoid contact! Risk of burns!
Gases or vapours drawn in by the compressor have
to be kept free of constituents that may cause fire or
2.2 / 3
explosions inside the compressor.
2850
When you disconnect the hose coupling, hold the
8
coupling element in your hand to prevent injury from
the whiplashing hose.
50
Wear goggles when working with the blow-out gun.
412
Injuries may easily result from foreign bodies and
blasted parts.
89.9
75.9
Never point the blow-out gun at other persons and
never use it to clean clothes that are still being worn.
IP 20
46
Note the safety instructions for paint
spraying!
Important! Note the pertinent accident prevent
regulations in force in your area!
● Never process paints or solvents with a flash point
below 21°C.
● Never heat paints or solvents.
● It is imperative to use filtering equipment (face
masks) when processing harmful liquids. Note
also the information concerning safety precautions
published by the manufacturers of these liquids.
● Smoking is prohibited during the spraying
operation and in the work room. Paint vapours are
highly flammable.
● Make sure there are no open fires or open lights in
the work room. Sparking machines are not to be
used.
● Do not keep or consume food and drink in the
work room. Paint vapours are harmful.
● The details and designations of the Ordinance on
Hazardous Substances, which are displayed on
the outer packaging of the processed material,
must be observed. Additional protective measures
are to be undertaken if necessary, particularly the
wearing of suitable clothing and masks.
● The work room has to be bigger than 30 m
have sufficient ventilation for spraying and drying.
GB
3 and
9