EINHELL EURO 4300 V Instructions De Service page 10

Anl Euro 4300 V_SPK1 08.09.2006
GB
Never spray into the wind.
It is always imperative to observe the regulations
of your local police authorities when spraying
combustible or hazardous substances.
● Never process media such as white petroleum
spirit, butyl alcohol and methylene chloride with
the PVC pressure hose (reduced life span).
Operation of pressure vessels in
accordance with the pertinent pressure
vessel regulations
1. An operator of a pressure vessel is required to
keep the pressure vessel in good working order,
to operate it properly, to supervise its use,
to carry out essential maintenance and repair
work immediately, and to introduce essential
safety measures according to requirements.
2. The supervisory authorities may order essential
safeguards from case to case.
3. A pressure vessel may not be operated if it has
any defects which constitute a danger to
employees or third parties.
4. The pressure vessel must be regularly inspected
for damage, e.g. rust. If you discover any
damage, then please contact the customer
service workshop.
Putting the compressor into operation
Assembling the wheels (1):
Fit the wheels as shown in Figure 1.
1
10
10:21 Uhr Seite 10
Assembling the rubber buffer
The enclosed rubber stops must be assembled on
the supporting foot in accordance with Diagram 2.
2
Replacing the oil filter and installing the air filter
(fig. 3)
Use a screwdriver to remove the oil filter plug and
insert the supplied stopper (2) in the
opening.Important! Check the oil level.
3
Changing the air filter:
Unscrew the guard hood of the pushbutton switch
(5). The air filter (1) can now be bolted to the side of
the pump, or disconnected.
Electrical connections:
The compressor is equipped with a mains cable with
shock-proof plug. This can be connected to any 230
V ~ 50 Hz shock-proof socket which is protected by a
16 A fuse. The motor is protected against overload
by a thermal overload switch (1). If the rated current
is exceeded, the overload switch (1) shuts down.
After the overload switch (1) has shut down, the
pressure switch should be switched off. After a short
cooling down period, the overload switch (1) can be
actuated again. By pressing the ON/OFF switch on
the pressure switch, the compressor can be switched