Important; Setting The Pressure Switch; Assembly And Starting - EINHELL TE-AC 36/6/8 Li OF Set-Solo Instructions D'origine

Important!

Use only batteries which are charged to the same
level. Never combine full and half-full batteries.
Always charge the two batteries simultaneously.
The equipment's operating time depends on the
battery with the lower charge level. The two batte-
ries must always be fully charged before use.
Close the battery cover by swinging it down, and
make sure that it latches in place correctly.
Installing the battery (Fig. 1b)
Flip up the battery cover (18) as shown in Figure
1b. Slot the two rechargeable batteries (12) into
the mounts.
Battery capacity indicator (Fig. 4)
Press the battery capacity indicator switch (a).
The battery capacity indicator (b) will indicate the
charge status of the battery by means of 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs blink:
The battery pack has undergone exhaustive di-
scharge and is defective. Do not use or charge a
defective battery pack.

6. Assembly and starting

Important!
You must fully assemble the equipment befo-
re using it for the fi rst time.
6.1 On/Off switch (Fig. 1a)
To switch on the equipment, set the On/Off switch
(8) to position 1.
To switch off the equipment, move the On/Off
switch (8) to position 0 .
6.2 Setting the pressure (Fig. 1a)
•
You can adjust the pressure on the pressure
gauge (6) using the pressure regulator (7).
•
The set pressure can be drawn from the
quick-lock coupling (5).
Anl_TE_AC_36_6_8_Li_OF_SPK9.indb 19 Anl_TE_AC_36_6_8_Li_OF_SPK9.indb 19
GB

6.3 Setting the pressure switch

The pressure switch is set at the factory.
Cut-in pressure approx. 6 bar
Cut-out pressure approx. 8 bar
7. Operation
7.1 Tire pressure gauge with adapters (Fig. 2)
Working pressure in bar: 0 – 8
Range of applications:
The tire pressure gauge (15) allows you to infl ate
car tires easily and exactly. Use the pressure
gauge to check the tire pressure. If the tire pres-
sure is too high, you can reduce the pressure with
the integrated relief valve (e). The tire pressure
gauge comes with a valve adapter for car tire
valves.
Warning! Observe the information supplied by
the tire manufacturer and the vehicle manufactu-
rer relating to the recommended tire pressure.
Warning! This equipment is not calibrated! For a
calibrated measurement value, check the actual
tire pressure using a calibrated meter after you
have infl ated the tires yourself, e.g. at a petrol
station.
Use as a blow-out pistol
To use the tire pressure gauge as a blow-out
pistol you must fi rst unscrew and remove the
hose with the valve adapter for care tires. Now the
blow-out adapter (16) can be screwed to the tire
pressure gauge.
Range of applications:
For cleaning and blowing out hollow spaces or
hard-to-reach areas, as well as for cleaning soiled
equipment. The infi nitely variable trigger lever al-
lows an exact dosing of compressed air.
- 19 -
Autogoods "130"
24.05.2019 11:53:52 24.05.2019 11:53:52