Table des Matières
Publicité
Anleitung BT-AC 12 V SPK1:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place, so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Important instructions!
Never clean your clothes with the compressed air.
Never direct the compressed air at other persons.
Keep all the ventilation slots clean.
Take care not to draw in dust or similar
contaminants with the compressor.
Protect the compressor from the rain, splashing
water and damp surroundings.
Do not stand the compressor on heated surfaces.
Do not use the cable for any purpose other than
that intended!
Never carry the compressor by its cable and never
pull the plug out of the cigarette lighter socket by
the cable. Protect the cable from heat, oil and
sharp edges.
Examine the machine for signs of damage.
Unless otherwise instructed by this manual, have
defective or damaged parts repaired or replaced
by a customer service workshop.
Operate only from a rated voltage of 12 volts
(direct voltage). Higher voltage ratings will destroy
the compressor.
Make sure there is reliable contact between the
socket-outlet and the plug. Poor contact will lead to
overheating and risk of fire.
The compressor is not suitable for permanent
duty.
Ensure that the compressor cools down for 20
minutes after it has run for 10 minutes.
12.10.2009
13:02 Uhr
Seite 5
2. Technical data
Power supply:
12V, from a cigarette lighter
socket or an Einhell Power Station
Pumping capacity:
max. 18 bar (250 psi)
Length of connection cable:
approx. 2,9 m
Length of air hose:
approx. 0.45 m
Check pressure gauge:
Operating time:
max. 10 minutes
3. Proper use
The equipment is designed for inflating car,
motorcycle and bicycle tires as well as balls and
small air mattresses.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Before putting the compressor into
operation
You can use the quick-release valve either directly or
in conjunction with one of the additional adapters,
depending on which type of valve is fitted to the item
you want to inflate.
To fit one of the additional adapters, proceed as
follows:
1. Arrange the clip of the quick-release valve so that
it points vertically up.
2. Now insert the adapter of your choice in the quick-
release valve.
3. Press down the clip in order to fasten the adapter
in the quick-release valve.
If you want to use the quick-release valve without an
adapter, plug the quick-release valve (clip open) over
the valve on the item you want to inflate
GB
0 - 18 bar
5
Publicité
Table des Matières
