Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL BT-AC 12 V Mode D'emploi D'origine

Anleitung BT-AC 12 V SPK1:_
GB
(see Figure 1).
Then press down the clip in order to fasten the quick-
release valve in place (see Figure 2).
5. Putting the compressor into
operation
1. Connect up the compressor as described above.
2. Insert the cigarette lighter plug in a matching 12V
cigarette lighter socket (e.g. in your car, caravan,
lorry, etc. / Figure 3).
3. The actual pressure is indicated by the check
pressure gauge.
4. To stop the compressor, pull the cigarette lighter
plug out of the socket.
6. Testing the air pressure
To use this function there is no need to connect up
the compressor.
Connect the quick-release valve to the item you want
to test as described in the section „Before putting the
compressor into operation".
The air pressure is now indicated on the check
pressure gauge.
You should always use a calibrated pressure gauge
to check the pressure on parts where a wrong
pressure level could prove fatal, e.g. car tyres.
For complete flexibility in the use of your car
compressor, i.e. independently of even your car,
caravan, lorry or similar, it is possible to operate the
compressor in combination with an Einhell Power
Station.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
6
12.10.2009 13:02 Uhr Seite 6
into the device.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.