Nice Mhouse SL1S Instructions D'installation Et D'utilisation page 58

One flash per second
2 long flashes
1 flash every 2 seconds
Series of flashes separated
by a pause
Quick flash
LED STOP [B]
Off *
On
LED OPEN [C]
Off
On
LED P1 [D]
Off *
On
Series of quick flashes,
from 1 to 4
5 quick flashes
1 slow flash
3 slow flashes
5 slow flashes
LED P2 [E]
Off *
On
1 flash per second
2 flashes per second
LED P3 [F]
Off *
On
* or it could be in "Standby" mode
46
A
24
Everything OK
Input status variation
Automation in "standby" mode
The same signal as for the flashing light,
see Table 12.
ECSBus short circuit
Status
STOP input activated
Everything OK
Status
Everything OK
OPEN input activated
Status
Everything OK
Memorisation mode 1
Memorisation mode 2
Deletion OK
Wrong command
Memorisation OK
Deletion OK
Status
Everything OK
Everything OK
The learning phase has not been carried
out or there are errors in the memory data
Device learning procedure underway
Status
Everything OK
Everything OK
B C
D
E
F
Control unit works correctly.
A variation to the status of the inputs OPEN, STOP, activation
of the photocells, or when the radio transmitter is used, is nor-
mal.
Everything OK; when the control unit receives a command nor-
mal operation is restored (with a short delay).
An overload has been detected therefore the power to the ECSBus
switched off. Check by disconnecting the devices one at a time.
To restore power to the ECSBus simply send a command, for
example with a radio transmitter.
Action
Check the devices connected to the STOP input
STOP input active
Action
OPEN input not active
This is normal only if the device connected to the OPEN input is
active
Action
No memorisation underway.
This is normal during memorisation mode 1 which lasts maximum
10 s.
This is normal during memorisation mode 2 which lasts maximum
10 s.
Deletion of a transmitter successfully completed.
Command received from a transmitter which is not memorised
Memorisation successfully completed
All radio transmitters successfully deleted
Action
"Slow" speed selected
"Fast" speed selected
Carry out the position learning procedure again (see paragraph
10.3.3 "Learning the connected devices")
It shows that the search for connected devices is underway (it
lasts maximum a few seconds)
Action
Cycle operation
Complete cycle operation