Balanced Body Rialto Reformer Mode D'emploi page 23

How to install your Reformer with Tower
BEFORE BEGINNING ASSEMBLY
These instructions include a parts list. Please use this list to make
sure you have all the parts necessary for installation. If you are
missing a part, please contact our customer service department
at 1-800-PILATES (1-800-745-2837).
REQUIRED TOOLS (INCLUDED)
» 3/16" Allen Wrench (GEN 8320)
» 5/32" Allen Wrench (GEN 9280)
PARTS FOR TOWER
DESCRIPTION
Tower Assy
Single cotton loops (pair)
Roll down bar
UV Safety Strap
Yellow trap short springs
Blue trap light springs
Yellow trap long springs
Purple trap medium springs
Mat conversion, Contoured
Mat conversion, Non Contoured
1. On the head end of the Reformer, loosen the top set screws in
each leg 3-4 turns using a 5/32" Allen wrench. Now, take off
the riser tower assembly from the Reformer and set it aside.
2. Remove the set screw from the bottom hole in each leg on
the head end of the Reformer using a 5/32" Allen wrench
provided. Set these two set screws aside. They will be used to
tighten the tower once it is installed. Remove the stopper
screw from the middle position in each leg on the head end of
the Reformer by using the provided 3/16" Allen wrench.
Thread the stopper screw in to the bottom hole in each leg
and tighten. See Figure A.
3. The Rialto tower comes with the pulleys and the Push Thru
Bar preinstalled. Remove the tower from the box and place it
carefully into holes in the legs in the head end of the
Reformer. Make sure that the loop on the tower is facing
forward, towards the carriage. See Figure B. The tower sets on
PART NO. QTY the stopper screw installed in Step 2.
16283 1
101-005 1
607-126 1
210-058 1
SPR9002 2
SPR9004 2
SPR9006 2
SPR9461 2
16083 1
16084 1
Fig A
Loop should
face the
reformer.
Fig B
Loosen top set screw
on both legs.
Move stopper screw to
this position.
21