Kärcher TB 36 Notice Originale page 47

Dis- Fault
play
226 Fault door 1, light barrier 1
227 Fault door 1, light barrier 2
228 Fault door 2, light barrier 2
229 Fault door 2, light barrier 1
234 Light barrier position 1 blocked
235 Light barrier position 2 blocked
236 Fault front drier light barrier / roof bar front
down
237 Fault middle drier light barrier / roof bar up
238 Fault rear drier light barrier / roof bar rear
down
239 Fault in high pressure sequence (light barrier
of high pressure roof bar activated for more
than 10 seconds)
240 Safety switch of high pressure roof bar has
been triggered during the wash cycle.
241 Fault of the high pressure roof bar during drive
into base position (light barriers, safety switch)
242 Fault of the high pressure roof bar light barrier
at the beginning of the wash cycle
245 No vehicle found after the wash programme
was started
246 Radio operator station out of order
247 Error while writing/reading via the USB inter-
face
248 Error while writing/reading the memory of the
control.
250 Unit has not been initialised
251 Emergency operations of processed water are
active
255 Fault, wash data invalid
Possible cause
Light barrier is contaminated, blocked or
defective
Obstacle, safety switch stuck
Light barrier is contaminated, blocked or
defective
Obstacle, safety switch stuck
Light barrier is contaminated, blocked or
defective
No vehicle in the wash system
Radio operator station switched off during
wash cycle or batteries of the operator
station depleted.
USB stick defective or memory full.
Memory of control full or defective.
Measurement drive has not yet been done Washing is not possible; call Custom-
Processed water unit has a fault
The updated wash data is no longer valid
or have the wrong version
21
-
EN
Remedy
Clean light barrier.
Turn off the equipment, wait, turn on
the equipment.
Clean light barrier.
Check the safety switch with the end
switches for ease of movement and
damages. Switch the system off and
back on, repeat wash cycle
Clean light barrier.
Turn off the equipment, wait, turn on
the equipment.
Drive vehicle in
Replace the batteries, switch on the
radio operator station and press the
"Start/Stop" key.
or
Press the "Start/Stop" key on a wired
operator station.
Delete the USB stick or used a differ-
ent USB stick.
Turn off the equipment, wait, turn on
the equipment.
If the event recurs, call Customer
Service.
Turn off the equipment, wait, turn on
the equipment.
If the event recurs, call Customer
Service.
er Service
Repair service water system
Use new wash data.
47