If an additional programme is selected,
–
the key will be illuminated
The additional programme can be
–
deselected by pressing the illuminated
key.
Option keys
Spoiler
selectable: before and during
the wash
deselectable: before the wash
Loading board wall
selectable: before and during
the wash
deselectable: before and during
the wash
Lorry mirror
selectable: before the wash
deselectable: before the wash
Bus mirror
selectable: before the wash
deselectable: before the wash
Centre cover
selectable: before and during
the wash
deselectable: before and during
the wash
2-brush wash (without roof
brush)
selectable: before the wash
deselectable: before the wash
Euro cabin
selectable: before the wash
deselectable: before the wash
US cabin
selectable: before the wash
deselectable: before the wash
If an option is selected, the key will be
–
illuminated.
The option can be deselected by press-
–
ing the illuminated key.
Wash card/code reader (option)
The choice of the wash programme de-
pending on the design of the wash card/
code reader
by entering on a keyboard,
–
through the programme stated on the
–
wash card,
by entering a code number.
–
Further information is obtainable in the sep-
arate operating instructions on the wash
card/code reader.
Automatic/manual switch
1 Automatic/manual switch
Controls
1 Display
2 LEFT key
3 RIGHT key
4 OK button
5 ESC button
The following display can be seen in the in-
itial state:
Total
Truck
Wash counter; the bottom line shows the
total number of single wash programmes
(lorry, lorry with trailer...) alternatingly.
Press the RIGHT button.
Total
Foam
Wash counter; the bottom line shows the
total number of different options (foam, in-
tensive...) alternatingly.
Press the RIGHT button.
Total
Cards
Wash counter start device; the bottom line
shows the total number of start devices of
the different cards (card 1, card 2...) alter-
natingly.
5
-
EN
Note
If there are fault messages displayed in-
stead, press the "OK" key.
The current error messages are redis-
played when no button is pressed for 30
minutes.
Press the RIGHT and OK buttons at the
same time when you want to display the er-
ror messages before the 30 minutes have
elapsed.
Press the ESC button for 2 seconds if a dif-
ferent display appears instead.
Configuration menu
Press OK button for more than 2 sec-
onds.
Press the LEFT button.
Press the RIGHT button.
Press the OK button.
The configuration menu is reached:
=#####
=#####
=#####
=#####
=#####
=#####
13.08.2008
15:54
< Info
Config.>
Selection
Error memory
Selection
Configuration
Selection
Speed
31