Kärcher TB 36 Notice Originale page 45

Dis- Fault
play
129 Front safety switch triggered
130 Rear safety switch triggered
131 The side brushes are powered when moving
in at the beginning of the brush wash
132 The roof brush is already powered when low-
ered at the beginning of the brush wash
133 Door on pillar 2 open
139 Protective motor switch of fresh water pump
was triggered
141 Frequency converter of lifting motor has got
switched off while operating the roof brush
142 Frequency converter of lift motor shut-off dur-
ing high pressure operation
143 Intensive cleaner empty
144 Fault in processed water
145 Fault in fresh water
148 Filling level of foam too low
149 Filling level of shampoo too low
150 Filling level of drying aid too low
155 Lack of water supply to high pressure pumps Water supply tank for high pressure
156 Protective motor switch high pressure pump 1
was triggered
157 Protective motor switch high pressure pump 2
was triggered
158 Protective motor switch high pressure pump 3
was triggered
159 Thermal switch high pressure pump 1 was
triggered
160 Thermal switch high pressure pump 2 was
triggered
161 Thermal switch high pressure pump 3 was
triggered
162 Pressure switch of high pressure pump was
triggered forward for roof nozzles
164 Pressure switch of high pressure pump was
triggered for side nozzles
166 Pressure switch of high pressure pump was
triggered for underbody cleaning
168 High pressure pump pressure switch still actu-
ated despite bypass circuit
Possible cause
The switch has been pressed by a person Reset switch manually and press
Vehicle is too far forward
Door in pillar 2 not closed
Protective motor switch in the pump
switching cabinet was triggered
Lift motor overloaded.
Detergent can empty
Fault in water preparation
Dry run of fresh water tank
Detergent container almost empty
pumps empty
Protective motor switch in the pump
switching cabinet was triggered
Motor of high pressure pump 1 too hot or
defective
Motor of high pressure pump 2 is too hot
or defective
Motor of high pressure pump 3 is too hot
or defective
High pressure nozzles of roof blocked to-
wards the front or compressed air supply
to the portal has stopped or pressure
switch is defective
High pressure nozzles of side pipes
blokked or compressed air supply to portal
has been switched off or pressure switch
is defective
High pressure nozzles of underbody
cleaning blocked or compressed air sup-
ply to portal has been switched off or pres-
sure switch is defective
Compressed air supply to the portal has
been stopped or pressure switch is defec-
tive
19
-
EN
Remedy
"Start/Stop" key to continue the wash
Position vehicle correctly
Close the door and press the "Start/
Stop" key to continue the wash.
Switch on the protective motor switch
again, repeat washing process, call
Customer Service
Check cable and lifting motors of the
roof brush and roof bar for damages,
switch on/ off the unit, repeat washing
process
Replace the empty can with a full one
Check service water tank and water
conditioning, notify Service
Check fresh water tank, check main
water pressure; repeat washing proc-
ess, call Customer Service
refill the corresponding detergent
Check water tank, repeat washing
process, call Customer Service
Switch on the protective motor switch
again, repeat washing process, call
Customer Service
Repeat washing process, emergency
operation possible by using the sec-
ond high pressure pump, call Cus-
tomer Service.
Repeat washing process, emergency
operation with first high pressure
pump is possible, call Customer
Service.
Repeat washing process, emergency
operation with first high pressure
pump is possible, call Customer
Service.
Clean the corresponding high pres-
sure nozzles, check compressed air
supply, repeat washing process, call
Customer Service
Check compressed air supply, repeat
washing process, call Customer
Service
45