5.
Scope of Delivery
Description
system knee joint (without figure)
set 2-component adhesive with primer (fig. 2)
assembly/lamination dummy (fig. 3)
lever extension (without figure)
connecting tube for lever extension (without figure)
6.
Load Capacity
The load capacity results from the relevant patient data and can be determined by using the Orthosis Config-
urator. Use the system components determined by the Orthosis Configurator when producing an orthosis and
mind the recommended production technique.
7.
Tools for Assembling the System Joint
Tools
T8 hexalobular screwdriver/bit
T20 hexalobular screwdriver/bit
torque screwdriver 1–6Nm
sliding washer centring pin
22
Quantity
1
1
1
1
1
fig. 2
System Width
20mm
x
x
x
x
fig. 3