Description; Purpose; Overview; Safety - GreenWorks G40LT Traduction Des Instructions D'origine

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

Figure 1 - 12.
Trigger
1
Lock-out button
2
Rear handle
3
Auxiliary handle
4
Upper shaft
5
Coupler
6
Lower shaft
7
Cut-off blade
8
Edge guide
9
Trimmer head
10
Guard
11
Screw
12
Knob
13
Release button
14
Positioning hole
15
Metal ring
16
Knob
17
Battery release button
18
Spool retainer button
19
Spool cover
20
Spool
21
Tab
22
Hole
23
Spool housing
24
Anchor hole
25
Slot
26
Direction of roatation
A
Best cutting area
B
Dangerous cutting area
C
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
WARNING
English
3

INSTALLATION

Remove the battery pack from the machine before
installation.
Do not use accessories that are not recommended for this
machine.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.2

ATTACH THE GUARD

Figure 2.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
3.3

ASSEMBLE THE SHAFT

Figure 3.
1. Loosen the knob on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole and
move the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
4
WARNING
WARNING
WARNING
WARNING
WARNING