Description; Purpose; Overview; Safety - GreenWorks G40PHA Manuel Opérateur

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is intended for cutting and trimming
hedges and bushes in domestic use.
1.2

OVERVIEW

Figure 1
1 Small safety lock
button
2 Blade
3 Hedge trimmer head
4 Coupler
5 Safety lock button
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

UNPACK THE MACHINE

Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.1

FIT THE HEDGE TRIMMER HEAD

Figure 2
The hedge trimmer head can be mounted directly into
handle pole so as to achieve the standard length.
1. Insert the handle pole into the hedge trimmer head.
2. Slide the coupler upwards and turn it clockwise until
it is completely tightened.
6 Trigger
7 Rear handle
8 Battery release
button
9 Pivoting button
WARNING
WARNING
WARNING
English
Periodically check the connections to ensure that they
are tightened securely.
3.2 REMOVE THE HEDGE TRIMMER
HEAD
Figure 3
1. Rest the machine on the ground.
2. Loosen the coupler.
3. Take off the trimmer head / handle pole.
3.3

INSTALL THE BATTERY PACK

Figure 4
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.4

REMOVE THE BATTERY PACK

Figure 4
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4

OPERATION

• Touch the blade carefully.
• Do not put your fingers into the notches or in
position where they can get cut.
• Do not touch the blade unless you remove the
battery pack.
• Do not use the machine if the blade is damaged or
bent.
• Remove all objects such as cords, lights, wire, or
string which can become entangled in the cutting
blade and create a risk of personal injury.
4
WARNING
WARNING