Description; Purpose; Overview; Important Safety Instructions - GreenWorks 21142 Manuel D'opérateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

1
2
3
Outlet end
1
Cord retainer
2
Trigger
3
Lock - out button
4
Auxiliary handle
5
Upper shaft
6
Coupler
7
Lower shaft
8
Gear box
9
Trimmer head
10
Guard
11
2
IMPORTANT SAFETY
INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING (THIS
POWER TOOL)
Read and understand all instructions before using this
product. Failure to follow all instructions listed below may
result in electric shock, fire, and/or serious personal injury.
4
5
6
7
8
11
10
WARNING
English
Use only identical manufacturer's replacement parts and
accessories. Use of any other parts may create a hazard or
cause product damage.
Always wear safety glasses with side shields marked to
comply with ANSI Z87.1. Everyday glasses have only
impact resistant lenses. They are NOT safety glasses.
Following this rule will reduce the risk of eye injury. Use
face mask if operating in dusty work spaces.
Avoid Dangerous Environment – Don't expose power
tools to damp or wet conditions. Water entering a power
tool will increase the risk of electric shock.
Don't use in rain.
Keep all bystanders, children, and pets at least 50 ft.
away.
Dress Properly – Do not wear loose clothing or jewelry.
They can be caught in moving parts. Use of rubber gloves
and substantial footwear is recommended when working
outdoors. Wear protective hair covering to contain long
hair.
Do not operate the equipment while barefoot or when
wearing sandals or similar lightweight footwear. Wear
protective footwear that will protect your feet and
improve your footing on slippery surfaces.
Use right Appliance. Do not use appliance for any job
except that for which it is intended.
Avoid Unintentional Starting – Don't carry appliance
with finger on switch. Be sure switch is off when battery
plugging in.
9
Don't Force Appliance – It will do the job better and with
less likelihood of a risk of injury at the rate for which it
was designed.
Don't overreach – Keep proper footing and balance at all
times.
Stay alert – Watch what you are doing. Use common
sense. Do not operate this unit when you are tired, ill or
under the influence of alcohol, drugs or medication.
Always store idle power tools indoors – When not in use,
power tools should be stored indoors in a dry and high or
locked-up place, out of reach of children.
Maintain Appliance With Care – Replace string head if
cracked, chipped, or damaged in any way. Be sure the
string head is properly installed and securely fastened.
Keep cutting edge sharp and clean for best performance
and to reduce the risk of injury. Follow instructions for
lubricating and changing accessories. Inspect appliance
cord periodically, and if damaged, have it repaired by an
authorized service facility. Inspect extension cords
periodically and replace if damaged. Keep handles dry,
clean, and free from oil and grease. Failure to do so can
cause serious injury.
Check damaged parts before using the appliance, a guard
or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, damaged
mountings, and any other condition that may affect its
operation. A guard or other part that is damaged should
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sta808

Table des Matières