Description; Purpose; Overview; General Power Tool Safety Warnings - GreenWorks G24ST25 Manuel Opérateur

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

Figure 1 - 16.
Trigger
1
Lock-out button
2
Upper shaft
3
Auxiliary handle
4
Middle shaft
5
Lower shaft
6
Guard
7
Trimmer head
8
Release button
9
Positioning hole
10
Knob
11
Bolt
12
Battery release button
13
Cut-off blade
14
Spool retainer button
15
Spool cover
16
Tab
17
Spool
18
Hole
19
Spool housing
20
Anchor hole
21
Guide slot
22
Direction of roatation
A
Best cutting area
B
Dangerous cutting area
C
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your battery-
operated (cordless) power tool.
WARNING
English
3

INSTALLATION

Remove the battery pack from the machine before
installation.
Do not use accessories that are not recommended for this
machine.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2

ATTACH THE GUARD

Figure 2 - 3.
Do not touch the cut-off blade.
1. Remove the screw from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw hole on the guard with the screw hole on
the trimmer head.
4. Tighten the screw.
3.3

ASSEMBLE THE SHAFT

Figure 4.
Never install, remove, or adjust any part of a machine while
the battery is installed in the machine or the machine is
running.
4
WARNING
WARNING
WARNING
WARNING
WARNING
WARNING