Description; Purpose; Overview; Safety - GreenWorks GD60BCB Manuel Opérateur

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2

OVERVIEW

Figure 1 - 20.
Battery release button
1
On/off button
2
Speed button
3
Lock-out button
4
Trigger
5
Auxiliary handle
6
Upper shaft
7
Coupler
8
Lower shaft
9
Trimmer head
10
Cut-off blade
11
Guard
12
Screw
13
Release button
14
Positioning hole
15
Knob
16
Cap
17
Lower support
18
Tab
19
Spool cover
20
Spool housing
21
Spool
22
Line exist hole
23
Slot
24
Angle transmission hole
25
Metal rod
26
Nut
27
Outer cup
28
Blade
29
Direction of roatation
A
Best cutting area
B
Dangerous cutting area
C
2

SAFETY

Make sure that you follow all safety instructions.
WARNING
English
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2

ATTACH THE GUARD

Figure 2.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
3.3

ASSEMBLE THE SHAFT

Figure 3.
1. Loosen the screw on the coupler.
2. Push in the release button on the lower shaft.
3. Align the release button with the positioning hole and
slide the two shafts.
4. Turn the lower shaft until the button locks into the
positioning hole.
5. Tighten the screw with the hex wrench.
3.4 ATTACH THE AUXILIARY
HANDLE
Figure 4.
4
WARNING
WARNING
WARNING