koban KPAW-01 Manuel page 151

KPAW-01
TRUE RMS 1000A AC WATT Clamp Meter
D. Apparent Power (main display) + Reactive Power
(secondary display) Measurement
Please refer to C
E. Reactive Power (main display) + Apparent Power
(secondary display) Measurement
Please refer to C.
F. Power Factor (main display) + Phase Angle
(secondary display) Measurement
Warning
To avoid damages to the Meter or harms to you, do you
measure higher than AC voltage 750V rms and AC
current 1000A rms.
To test for Power factor (main display) + Phase angle
(secondary display), connect the Meter as follows:
1. Dial the Rotary to cosθ to select Power factor + Phase
angle range.
2. Press the lever to open the transformer jaw, and clamp
them to the corrresponding phase of tested conductor. If
user needs to mesaure any phase of the 3 phase, then
clamp them to that phase's conductor.
3. The connecting method of 3 phases 4 wires or 3
phases 3 wires, refer to figure 6 and 15
4. When measuring 3 phase 4 wires: (see figure 18, 19 and
20)
Press SEL to choose the first phase , see figure 18.
26 www.grupotemper.com