koban KPAW-01 Manuel page 141

KPAW-01
TRUE RMS 1000A AC WATT Clamp Meter
lead (COM input terminal) to the corresponding three
phases loaded neutral wire.
4. Press SEL to select phase location, the display shows the
corresponding phase symbol. L1 means the first phase
L2 means the second phase
.
5. The display shows the corresponding True RMS voltage
value and frequency value of each phase.
6. Press MAXMIN, the LCD displays
recording the maximum AC voltage True RMS value.
7. Press MAXMIN the LCD displays
the minimum AC voltage True RMS value. Press MAXMIN
again to show the current AC voltage True RMS value.
8. The display shows 0L when the input voltage is higher
than 750V rms.
Note
When the measurement has been completed,
disconnect the connection between the testing leads and
the circuit under test and remove testing leads from the
input terminals.
16
, L3 means the third phase
, it starts
, it starts recording
www.grupotemper.com
,